我们常遇到设备的装、运、安装等项工作,不论是采用扒杆起吊或是机械吊装都应注意以下几点:(1)土法施工用的滚动法装卸移动设备,滚杠的粗细要一致,年度应比托排宽度长50cm,严禁带手套填滚杠。装卸车时滚边的坡度不得大于20,滚道的搭设要平整、坚实,接头错开,滚动的速度不宜太快,必要时要用溜绳。
吊装就位:由总指挥正式下令各副指挥,检查各岗位到岗待命情况,并检查各指挥信号系统是否正常;各岗位汇报准备情况,并用信号及时通知指挥台;正式起吊,使设备离开临时支座500—800mm时停止,并作进一步检查,各岗位应汇报情况是否正常;撤除设备支座及地面杂物,继续起吊
回转作业时,不要紧急停转,以防吊物剧烈摆动发生危险。 (2)回转中司机要注意机上是否有人或后边有无障碍危险。 (3)不回转时将回转制动锁住。 3、起重臂伸缩臂杆。 (1)不得带载伸臂杆。 (2)伸缩臂杆时,应保持吊臂前滑轮组与吊钩之间有一定距离。起重外臂外仲时,吊钩应尽量低。 (3)主付臂杆全部伸出,臂角不得小于使用说明书规定的较小角度,否则整机将倾覆。