在架体上或建筑物上安装设备时,其强度和稳定性要达到安装条件的要求。在设备安装定位后要按图纸的要求连接紧固或焊接,满足了设计要求的强度和具有稳固性后,才能脱钩,否则要进行临时固定
(2)在安装过程中,如发现问题应及时采取措施,处理后再继续起吊。(3)用扒杆吊装大型塔类设备时,多台卷扬机联合操作,必须要求各卷扬机的卷扬速度大致相同,要保证塔体上各吊点受力大致趋于均匀,避免塔体受力不匀而变形。
吊装就位:由总指挥正式下令各副指挥,检查各岗位到岗待命情况,并检查各指挥信号系统是否正常;各岗位汇报准备情况,并用信号及时通知指挥台;正式起吊,使设备离开临时支座500—800mm时停止,并作进一步检查,各岗位应汇报情况是否正常;撤除设备支座及地面杂物,继续起吊