1、Mn13高锰耐磨钢板的切割,建议采用等离子切割。 等离子切割分为水下等离子和空气等离子切割两种。采用水下等离子切割时,等离子气体可产生几千度的高温,高锰钢板切口处迅速熔化,并因水的阻隔避免了氧化,水又对钢板及时进行冷却,阻止碳化物析出,使钢板切割面光滑平整,无热影响区,切割质量***,是切割高锰钢的***。也可采用空气等离子切割。
Mn13高锰耐磨钢板的焊接: 高锰耐磨钢板的焊接可采选用手工电弧焊的方法。 焊条选用D256(堆256)或D266(堆266)焊条;焊接前应打磨焊缝,要***清理工件坡口及边缘,去除铁锈、油污,同时将焊条烘干;焊接时,应选择小直径焊条(一般为3mm-3.5mm),小电流、高电压、多焊层、多焊道、快速焊接;如采用直流焊接,焊条接正极;焊接每层后要锤击焊缝,以提高其抗热裂纹能力。也可使用流动水快速降温。
高锰钢是指含锰量在10%以上的合金钢,一般钢中锰元素的含量大于7%的,并以 锰元素为主的材料属于高锰钢。目前还很少有经轧制的高锰钢板,基本上是铸造的。高锰钢按照***分为5个牌号,主要区别是碳的含量,其范围是0.75%~1.45%。受冲击大,碳含量低。而一般不低于13%的高锰钢尚无***。只是锰含量大于18%,其中硅含量的高低,对冲击韧性影响较大,以不大于0.5为宜。