首先,将进水开关打开,在压力加到2时关闭(压力不要超过3) 其次,打开后一组暖气片的泄气阀,一种带有很怪的味道“老水“会喷出来;然后,等老水不在喷或流出来时,关闭泄气阀,第二次打开进水开关加压至2或3;接着,反复N次的泄水和加水,至您自己满意为止。 后,决定不反复冲洗后, 后一次加压不要超过1.5(多不超过2) 清洗水垢建议用***清洗剂,加入管道中,循环去除水垢就可以,因为清洗剂不容易损坏壁挂炉内的管道,从而延长壁挂炉的寿命。秋天和入冬时要对燃气壁挂炉再进行一次冲洗和换水,但加压一定不能超过1.5,压力过高时可打开后一组暖气片的泄气阀,放出一些水就行了。 注意壁挂炉采暖系统不可以长期处在无水状态下,这样会加快采暖系统的氧化腐蚀进程,不利于采暖系统保养。还要注意水中的杂质。 虽然在燃气壁挂炉水路入口处一般都会有过滤网,但是一些小的杂质还是不能被滤掉,长久之后,就会堵住换热器管路,这种现象在一些***机型上颇为常见,因为这些***机型大多采用板式换热器,孔隙小,径流量小,所以易堵。
1、打开进水口; 2、将壁挂炉清洁剂与水按1:10(体积比)的比例混合,配成液加入到存水箱;对于顽固水垢可直接倒入原液,浸泡5-15分钟即可,轻松瓦解水垢。 3、让其自动热循环(浸泡)20-30分钟,从排水口直接排干清洗液; 4、打开进水口,加满水后再循环两分钟; 5、排干后即可正常使用。
1、打开前锋壁挂炉进水口。2、将前锋壁挂炉***清洗液和配成除垢剂溶液加入到清洗换热器。(不一样的清洗液配度不一样)3、使除垢剂溶液充分接触前锋壁挂炉换热器各个部位,让溶液在换热器内浸泡2-4个小时,水垢完全溶解后。4、打开前锋壁挂炉排水口,排干清洗液。5、将清洗系统加满水冲洗2遍后即可正常使用。