但是只要有关几何精度检验合格,预调精度不检查也可以。所以预调精度是过渡性的精度,不是交工验收的精度。而且当发生几何精度达不到规定时,允许调整相应部件的预调精度,该部件的预调精度在交工验收时不再复检
、每一垫铁组应放置整齐、平稳且接触良好。3、机床调平后,垫铁组伸人机床底座底面的长度应超过地脚螺栓的中心,垫铁端面应机床底面的外缘,平垫铁宜10 -30mm,斜垫铁宜10 -50mm,螺栓调整垫铁应留有再调整的余量。
组装机床的部件和组件应符合下列要求:(1)、组装的程序、方法和技术要求应符合设备技术文件的规定,出厂时已装配好的零件、部件,不宜再拆装;(2)、组装的环境应清洁,精度要求高的部件和组件的组装环境应符合设备技术文件的规定;(3)、零件、部件应清洗洁净,其加工面不得被磕碰、划伤和产生锈蚀