(2)每小时检查润滑站供回油管路温度不超过50度,回油油量充足,油箱内油面的高度正常。润滑管路或油泵圆锥主体无漏油现象。
3检查,修理或更换调整环,支承环,弹簧及弹簧螺栓; 4、校正整个破碎机的技术性能.并可根据具体情况进行技术改造. 制订检修周期的办法有两种:一是根据破碎多少吨矿石;二是按负荷运转多长时间来确定。
(3)破碎机空负荷运转1-2分钟后,才能开启皮带,开始给矿,可以挤满给矿,注意给矿是否正常,尤其是含泥多、水分高的矿石,要防止矿石堵塞给矿口。