MBR膜4 抗污染膜元件对温度的要求被处理污水温度一般应低于35℃,温度过高将影响生物处理效果和滤膜的使用寿命。但在某些耐高温微生物处理系统应用,滤膜的允许温度可为45℃。5 抗污染膜元件对化学污染物的要求进水中不得含有高分子絮凝剂、环氧树脂涂料及离子交换树脂的溶出物,这些化学物质会在膜表面形成化学污染,造成透水量的降低。
MBR膜上发生了污染,就会使抽吸压力上升,如果不采取措施继续运行会使产水量下跌,因此必须进行清洗使膜性能恢复。清洗周期:一般1个月要在线清洗一次。2) 酸洗: 配制1000mg/L 草酸溶液,在线清洗,水量同上,浸泡1小时。2 物理清洗当在线化学清洗无法解决问题时,需要将膜元件从组件取出,放在平整的地面或干净容器中,用压力水柱冲洗膜表面。
MBR膜抗污染 MBR 的调试(1)提供和准备调试所需的药剂等。(2)熟悉工艺流程,检查现场管路走向,进行试水,检查水泵、风机等运行正常。(3)进行清水试验,确定系统在清水情况下正常运行。(4)在线清洗,反洗泵进水压力≯0.1MPa,进水流量1.5倍于设计产水流量。(5)MBR池污泥接种至2500mg/L-3000 mg/L时,方可进行膜组件的抽吸,且抽吸水量为设计水量的30%~40%。