0、支腿不应靠近地基按方地段。 11、应预***进行调查地下埋设物,在埋设物附近放置安全标牌,以引起注意。 12、确认所吊重物的重量和***位置,以防超载。13、根据起重作业曲线,确定工作台半径和额定总起重量即调整臂杆长度和臂杆的角度,使之安全作业。 14、应确认提升高度。根据吊车的机型,能把吊钩提升的高度都有具体规定。
吊装就位:由总指挥正式下令各副指挥,检查各岗位到岗待命情况,并检查各指挥信号系统是否正常;各岗位汇报准备情况,并用信号及时通知指挥台;正式起吊,使设备离开临时支座500—800mm时停止,并作进一步检查,各岗位应汇报情况是否正常;撤除设备支座及地面杂物,继续起吊。
轮胎式吊车需带载行走时,道路必须平坦坚实,载荷必须符合原厂规定。重物离地高度不得超过50cm,并拴好拉绳,较慢行驶,严禁长距离带载行驶。