双钳口自动校准平行i气动钳夹 (DH系列)
• 具有可选弹簧的双动作（正常关闭和正常启动）。
• 长行程或者短行程(1)。
• 可以使用通孔螺丝进行前紧固(2)。
• 动力传动效i率高(1)。
• 可选电磁式或电感式的传感器(3)。
• FDA-H1 食品级润滑脂。
2-jaw self-centering pneumatic parallel gripper
(series DH)
• Double acting with optional springs (normally closed or
normally open).
• Long stroke or short stroke (1).
• P05sibility of front fastening with through screws (2).
• High efficiency force transmission (1).
• Optional magnetic or inductive sensors (3).
• FDA-H1 food-grade grease.
MGX系列自动对准双钳口平行i气动钳夹
• 平直侧面。
• 坚固导道。
• 高夹紧力。
• 重量轻、尺寸小。
• 高精度尺寸。
• 可带关闭弹簧(-NC)或开启弹簧(-NO)。
• FDA-H1 食品级润滑脂。
2 parallel self-centering pneumatic gripper
series MGX
• Flat profile.
• Robust guide.
• High gripping force.
• Small weight and dimensi0ns.
• High dimensional accuracy.
• Spring closed (-NC) or spring open (-NO) option.
• FDA-H1 food-grade grease.
编程单个SB8F
在对传感器盒进行编程之前，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，直到READING红灯开始闪烁，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，启用了输出。黄灯（STORED）指示启用输出。
Before programming the sensor box, make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for 3 seconds until the READING red light starts fashing, then release it.The red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).
双钳口自动对准平行i气动钳夹 (SX系列)
•双动作 (可按需关闭)。
•高夹紧力。
•防护等级为IP67。
•列柱向上采用双层O型圈设计。
•适用于恶劣的环境。
•可选的磁传感器。
•FDA-H1 食品级润滑脂
•Double acting (normally closed on request).
•High gripping force.
•Protection class: IP67.
•Double O-Ring sealing on the columns.
•Suitable for harsh environments.
•Optional magnetic sensors.
•FDA-H1 food-grade grease.
以上信息由专业从事快速切换器原理的吉玛泰克于2024/7/17 12:22:50发布
转载请注明来源：http://m.tz1288.com/qynews/jmtkzdh-2787416157.html
下一条：武汉护坡砖信息推荐「康瑞得」
