双钳口自动校准平行i气动钳夹 (DH系列)
• 具有可选弹簧的双动作（正常关闭和正常启动）。
• 长行程或者短行程(1)。
• 可以使用通孔螺丝进行前紧固(2)。
• 动力传动效i率高(1)。
• 可选电磁式或电感式的传感器(3)。
• FDA-H1 食品级润滑脂。
2-jaw self-centering pneumatic parallel gripper
(series DH)
• Double acting with optional springs (normally closed or
normally open).
• Long stroke or short stroke (1).
• P05sibility of front fastening with through screws (2).
• High efficiency force transmission (1).
• Optional magnetic or inductive sensors (3).
• FDA-H1 food-grade grease.
双钳口非自动校准中心斜口气动夹具 PB系列
• FDA-H1 食品级润滑脂。
• 提供 6 毫米、8 毫米和 12 毫米孔径三种尺寸。
• 位于颚式钳尖部或尾部的传感器。
• 带齿（用于浇口抓持）或者带衬垫（用于软接触）的颚式
钳。
• 铝质或钢质颚式钳
2-jaw n0n-selfcentering angular pneumatic sprue
gripper series PB
• FDA-H1 food-grade grease.
• Three available sizes with piston bore 6mm, 8mm, 12mm.
• Sensor on the tip of the jaw, or on the tail.
• Jaws with teeth (for sprue gripping), or with pads (for soft
contact).
• Jaws in aluminium or steel.
编程单个SB8F
在对传感器盒进行编程之前，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，直到READING红灯开始闪烁，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，启用了输出。黄灯（STORED）指示启用输出。
Before programming the sensor box, make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for 3 seconds until the READING red light starts fashing, then release it.The red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).
以上信息由专业从事机器人夹具快速切换器的吉玛泰克于2024/5/11 12:43:38发布
转载请注明来源：http://m.tz1288.com/qynews/jmtkzdh-2750943538.html
