洁净室抓持解决方案
通过集成 KIT-GMP-G,Gimatic 电动抓持器可以在要求高标准清
洁度和卫生度的环境中运行。采用适配器能够将电动抓持器紧
固到机器人接口(需另行购买)并通过可灭菌硅氧烷罩盖保护
其运行。可以通过特殊的卫生不锈钢螺丝紧固抓持手指(需另
行购买)。系统满足zui严格的 GMP(良好生产规范)A B级清洁度标准。
其主要特征是:
• 适用于抓持器 MPPM1606。
• 兼容 GMP A B 级清洁度标准。
• 采用硅氧烷 Silpuran®Wacker FDA 21 CFR §177.2600 制造的罩
盖。
• 兼容过氧i化氢 (VHP-H2O2) 和 UV 清洁程序。
• 整个系统符合 IP65 防护等级。
• MPPM1606-KIT-GMP 套件通过 ISO14644-1 认证,适用于 ISO
2 洁净室,而单抓持器 MPPM1606 通过 ISO14644-1 认证,适用
于 ISO 4 洁净室。
• 不锈钢卫生螺丝 (Novonox)。
• 透明表面便于读取内部传感器的 LED 灯和电源状态 LED 灯。
• 卫生设计表面防止聚积细菌。
• 采用防旋转系统便于紧固抓持手指。
传感器
磁性传感器(可选) 通过活塞上的一个磁铁检测出操作位置。因此,大量的磁性材料和强烈的磁场可能会造成传感问题。
The operating position is detected by proximity magnetic sensors
(optional) through a magnet p1aced on the piston.
Therefore, avoid using the gripper in the vicinity of intense
magnetic ffelds or near a large mass of ferromagnetic material
as this may cause detection errors.
可选的推进器
这个配件可安装在TH钳夹上,用推进力F在钳夹打开时保持负载。例如,卡盘夹紧设备时载重。
This accessory can be installed in the TH grippers, to hold thepayload during the gripper release, by a pushing force F.
As an example, when the chuck of a machining equipment isloaded.
以上信息由专业从事海绵吸具厂商的吉玛泰克于2024/7/28 12:04:28发布
转载请注明来源:http://m.tz1288.com/qynews/jmtkzdh-2793071543.html