编程单个SB8F

在对传感器盒进行编程之前，电动旋转装置，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，直到READING红灯开始闪烁，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，启用了输出。黄灯（STORED）指示启用输出。

Before programming the sensor box，机械旋转装置， make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for  3 seconds until the READING red light starts fashing， then release it.The  red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).

传感器

可以通过一个 3 输出可编程传感器（需另行购买）检查运行位置，丽水旋转装置，该传感器用于检测嵌入右侧颚形钳的磁体位置。

The operating position can be checked by one 3 - outputs programmable sensor (not included)， detecting the position of the magnet on the right jaw.

SBMS/SBMS-E - 从模块

每个单独的从模块均可以连接单个传感器。它由内部总线连接（由主模块提供）供电，并触发两个固态继电器的换向：基于传感器输出的常开触点和常闭触点。两个选择器可用于配置传感器信号输出（PNP/2线或NPN）和逻辑（正向或反向）。该模块还有两个用于诊断的LED指示灯。

Each individual slave module enables the connection of a singlesensor.

It is powered from the internal bus connection (provided by themaster module) and triggers the commutation of two solid staterelays: a NO contact and a NC contact based on sensor output.

Two selectors are available to conffgure sensor signal output(PNP/2 wires or NPN) and logic (direct or reverse).The module also has two LED indicators for diagnostics.

机械旋转装置-丽水旋转装置-常熟吉玛泰克自动化(查看)由吉玛泰克自动化工程（常熟）有限公司提供。吉玛泰克自动化工程（常熟）有限公司位于江苏省常熟市古里镇通华路1号2幢。在市场经济的浪潮中拼博和发展，目前吉玛泰克在气动工具中享有良好的声誉。吉玛泰克取得全网商盟认证，标志着我们的服务和管理水平达到了一个新的高度。吉玛泰克全体员工愿与各界有识之士共同发展，共创美好未来。