Ｅ、抽油杆扶正器E，莫诺， sucker rod centralizer抽油杆扶正器由心轴和扶正筒组成，它接在两根抽油杆之间，被卡在两个抽油杆接箍之间。心轴也就是一要极短的抽油杆短节。扶正筒是一个内孔比心轴大１ＭＭ左右的空心塑料筒，外部有四个略比油管内径小的扶正翼，采取浇注成型。扶正筒可以围绕心轴转动，防止抽油杆旋转时与内壁接触而磨蚀油管，又可以让流体通过。The sucker rod centralizer is comed of the heart shaft and the upright cylinder， which is connected between the two sucker rods and is stuck between the two sucker rod hoops. The axis of the heart is also an extremely short rod short section. The centering cylinder is a hollow plastic tube inner hole Bixin shaft around 1MM， external four slightly smaller than the diameter of the tubing centralizer wing， adopt casting. The centralizer can revolve around the axis to prevent the sucker rod from touching the inner wall when it rotates， and it can also let the fluid pass through.




定转子过早磨损Premature wear of fixed rotor定转子过早磨损主要是由于定转子的间隙过小引起的。The premature wear of the fixed rotor is mainly caused by the small gap between the fixed rotor and the rotor.油管与抽油杆柱磨损Oil pipe and rod string wear油管与抽油杆柱磨损的原因一是因为井斜抽油杆贴在油管壁上引起的，可以通过加抽油杆扶正器使抽油杆柱居中来减轻或消除，另一个原因是定转子不同心及转子的偏心运动造成的，在定子以上加一节内径较大的回转筒即可避免。Tubing and sucker rod wear reason is because the deviation of sucker rod attached to the tubing wall caused by heating， pumping rod centralizer make the rod center to reduce or eliminate， another reason is caused by the eccentric motion of the rotor and the rotor are not concentric， avoid a day the diameter of rotary cylinder in the stator can be larger than.



莫诺-螺耐斯(推荐商家)由武汉螺耐斯环保设备有限公司提供。莫诺-螺耐斯(推荐商家)是武汉螺耐斯环保设备有限公司今年新升级推出的，以上图片仅供参考，请您拨打本页面或图片上的联系电话，索取联系人：尤经理。